Instructions

- 5 -
DO NOT BLINDLY FOLLOW THE ORDER OF THE
COMPONENTS ONTO THE TAPE. ALWAYS CHECK THEIR
VALUE ON THE PARTS LIST!
•
•
• Thin raisin-core solder. Do not use any ux or grease.
• A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they cannot
y towards the eyes.
•
• Small blade and Phillips screwdrivers. A basic range is ne.
)
• Make sure the skill level matches your experience, to avoid disappointments.
•
•
•
•
• Use the check-boxes to mark your progress.
•
* Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaet.
Trim excess leads as close as possible to the solder joint
- 4 -