User Manual

11
Required parts: Solar cell, 100 ohm resistor (brown black brown gold), yellow led,
microcontroller (µC), wire jumper.
How it works: The controller
requires 2-5V to operate. This
voltage is supplied by the solar
panel. The microcontroller is
pre-programmed with software
that turns the output on and off
in a loop. The signal is output
via pin 4. When the output is
on, current flows via the led and
the resistor, hereby causing the
led to light.
µC
SOLAR C ELL
VDD
2
VSS
7
GP3/MCL R/VPP
8
GP2/T 0CLKI/FO SC4
3
GP1/IC SPCLK
4
GP0/IC SPDAT
5
IC1
PIC10F20 0-I/ PG
LD1
R1
10 0