User Manual

3. ASSEMBLY WHEATHEART - HYDROSTATIC BIN SWEEP
3.2. HYDRAULIC PUMP KIT INSTALLATION (PORTABLE MODEL)STANDARD, PORTABLE, TRUCK MOUNT, & SUPER SWEEP
16 IM1 R3
Figure 3.5
3.2.3. HYDRAULIC HOSE INSTALLATION
INSTALLATION WITHOUT MOVER KIT:
1. Assemble hose as per Figure 3.6 and 3.7. When assembling hoses, make
sure to keep the pressure and return sides in the correct position.
2. Install a 4' x 3/4” diameter suction hose from the reservoir to the “IN” port on
the pump using the hose clamps provided.
3. Assemble the rest of the hoses as shown. Keep the hoses free of dirt while
assembling.
Note: Figure 3.7 illustrates how to hook up the bin sweep to a self-propelled auger kit.
NOTICE
DO NOT OVER-TIGHTEN! Over-tightening hoses can
crack motor body, causing the fittings to leak, and will void
the motor warranty.