Owner's manual

WHEATHEART - PORTABLE DRIVE OVER PIT 3. ASSEMBLY
10" & 13" 3.1. INSTALLING RAMPS
30686 R0 15
3. Assembly
The Portable Pit, as shipped from the factory, does not have the ramps and ramp
lift-springs installed. Follow the procedures below to complete the Portable Pit
assembly.
3.1. INSTALLING RAMPS
Refer to Figure 3.1.
1. Align the ramp with the frame tabs so that the frame tabs fit on the outside of
the ramp.
2. Install a 3/4” x 2-1/2” bolt, 2 plate washers, and a nylon locknut in the order
shown. Do not tighten completely, as ramps must be free to move in slots.
3. Repeat for all 4 ramps.
Figure 3.1 Ramp Installation
Warning: Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.