Owner's manual

3. ASSEMBLY WHEATHEART - SA FLEX AUGER
3.15. LOW PROFILE HOPPER 71’ - 111’
68 30651 R5
3. Thread cable through pulley on lift arm and wrap around the winch drum,
starting at the top. Cable must have at least 3 complete wraps around the
drum when intake hopper is fully lowered (Figure 3.59). Trim excess cable.
4. Tighten all hardware.
5. Install the valve, hydraulic fittings, and mount plate (Figure 3.58 and 3.60).
6. Connect hydraulic winch hoses to the valve on the front of the auger (Figure
3.60).
7. After the hydraulic system is completed, start the system and slowly activate
the hydraulic winch valve to take up the excess cable.
Figure 3.58
WARNING
Falling auger hazard.
To prevent serious injury or death while
winching, ensure cable is fed onto the winch
drum as described.Replace cable if frayed or
damaged.
ITEM PART NO. DESCRIPTION QTY.
1 28879 HOPPER LIFT ARM WELD’T, MK FLEX 1
2 28885 LIFT ARM SPINDLE WELD’T, MK FLEX 2
3 18155 COTTER PIN, 3/16” x 1-1/4” 2
4 28836 LIFT ARM PULLEY ASSY, MK FLEX 2
HYDRAULIC WINCH KIT ONLY
ITEM PART NO. DESCRIPTION QTY.
5 17634 HYD WINCH ASSY 1
6 17675 HYDRAULIC VALVE 1