Instruction Manual

3. ASSEMBLY WHEATHEART MANUFACTURING - TRANSFER AUGER
3.2. HYDRAULIC DRIVE TRANSFER ASSEMBLY 8”, 10”, & 13”
18 IM2 R2
Figure 3.3
Figure 3.4
3.2. HYDRAULIC DRIVE TRANSFER ASSEMBLY
Refer to Figure 3.5 – 3.8 for assembly of Transfer Augers with hydraulic drive
kits.
1. Insert a 3/8” x 2” bolt (2) through the hydraulic motor shaft (1) and secure to
upper auger shaft with a 3/8” locknut (3).
2. Mount hydraulic motor (1) to upper auger tube using four 3/8” x 3/4” bolts (4).
Note: Install bolts through tube end plate from inside.

8" MODEL:
1. Remove the plate protecting the top of the hydraulic motor and place #112 o-
rings into the recessions in the top of the hydraulic motor.