Specifications

Model SK-4224 Fire Control Panel Installation/Operation Manual
4-18 151068
4.7.3.5 Mounting the SK-2880
The I/O module must be mounted in a UL Listed enclosure.
Follow these steps to mount the SK-2880:
1. Remove the SK-2880’s cover. A small screw driver can be used.
2. Remove the SK-2880 circuit board from the base by pushing outward on the base retain-
ing tabs and lift the circuit board out. See Figure 4-17.
Figure 4-17 Circuit Board and Plastic Base Components
3. Mount the plastic base in a UL listed enclosure using any of the mounting holes in the
plastic base. See Figure 4-18 for locations of base mounting holes.
Figure 4-18 Base Mounting Holes
Verify the proper wire termination and then snap the I/O module cover in place.
Base
Base
Retaining
Tabs
Circuit
Board
Mounting
Holes
Mounting
Holes
Mounting
Holes