Owner's Manual

12
■ Overtightening bolts may warp the top of the microwave
provide) may be added. The blocks must be the same
thickness as the space between the upper cabinet
bottom and the microwave oven.
NOTE: Avoid damage to the mounting nut, screw the bolts into
sure the bolts thread in properly. Then tighten with tools.
2. Connect vent to damper assembly.
Complete Installation
1.
3. Plug microwave oven into grounded 3 prong outlet.
Dispose of/recycle all packaging materials.
4. Reconnect power.
5.
6.
Check the operation of microwave oven by placing 1 cup
time of 1 minute at 100% power. Test vent fan and exhaust
by operating the vent fan.
A. Vent
B. Damper assembly
(under vent)
A B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A. Bolt
B. Mounting Nut
A
A. Bolts
A. Bolts
15-20 mm
A
B
4. With front of microwave oven still tilted, thread power supply
cord through the power supply cord hole in the bottom of the
upper cabinet.
5. Rotate microwave oven up toward upper cabinet.
NOTE: If venting through the wall, make sure the damper
6. Push microwave oven against mounting plate and hold in
place.
NOTE: If microwave oven does not need to be adjusted, skip
steps 6 through 8.
7. If adjustment is required, rotate microwave oven downward.
Using 2 or more people, lift microwave oven off of mounting
plate, and set aside on a covered surface.
8. Loosen mounting plate screws. Adjust mounting plate and
retighten screws.
9. Repeat steps 3 through 6.
10. With the microwave oven centered, and with at least one
person holding it in place, insert bolts through upper cabinet
into microwave oven. Tighten bolts until there is no gap
between upper cabinet and microwave oven.
NOTES:
■ Some upper cabinets may require bolts longer or shorter
than 3" (7.6 cm). Longer or shorter bolts are available at
most hardware stores.
2.
Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
(250 mL) of water on the cavity and programming a cook
Check the vent door if auto open (in some models).