Owner's Manual

Rotate Blower Motor for Wall Venting Installation
1. Remove screws attaching damper plate to back of
microwave oven, set the screws aside.
2. Turn and hold the damper plate vertically as shown.
3. Remove 2 blower screws attaching blower motor to the
microwave oven, and set aside.
4. Disconnect the blower motor wire from the connector.
5. Lift blower motor out of microwave oven, and set aside.
A
B
A. Damper plate
B. Screws
A
A. Damper plate
A
A. Blower screws (in recessed holes)
A
B
A. Blower motor wire
B. Connector
A
A. Blower Motor
13
7. If the microwave oven does not operate:
■ Check that a household fuse has not blown, or that a
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.
■ Check that the power supply cord is plugged into a
grounded 3 prong outlet.
■ See the User Instructions for troubleshooting information.
The installation is now complete.
Save Installation Instructions for future use.
Wall Venting Installation
Install the microwave for wall venting as following steps:
a. Find the wall stud(s), refer to the “Find The Wall Stud(s)”
section.
b. Mark rear wall, refer to the “Mark Rear Wall” section.
c. Drill holes in rear wall, refer to the “Drill Holes in Rear Wall”
section.
d. Attach mounting plate to wall, refer to the “Attach Mounting
Plate to Wall” section.
e. Prepare upper cabinet, refer to the “Prepare Upper Cabinet”
section.
f. Rotate blower motor as the following “Rotate Blower Motor for
Wall Venting Installation” section.
i. Install damper assembly as the folloing “Install Damper
Assembly” section.
j. Install the microwave oven, refer to the “Install the Microwave
Oven” section.
k. Install grease lter and check that all parts are installed, refer
to “Complete Installation” section.