Owner's Manual

16
6. Using diagonal wire cutting pliers, gently snip out the
rectangular vent covers on the damper plate at the
perforations.
7. Lower blower motor back into microwave oven. Exhaust
ports face the top of microwave oven.
IMPORTANT:
side facing the back of the microwave oven (as shown),
performance will be poor.
8. Reconnect the blower motor wire into the connector.
9. Reattach the 2 blower screws into the recessed holes in the
back of the microwave.
10. Check to make sure the 2 screws are secured properly in the
blower motor screw holes, so that the motor cannot move.
11. Return the damper plate to its original horizontal position.
B
A
A. Rectangular vent covers
B. Diagonal wire cutting pliers
A
A. Exhaust port
A. Damper plate
A
3. Remove 2 blower screws attaching blower motor to the
microwave oven, and set aside.
4. Disconnect the blower motor wire from the connector.
5. Lift blower motor out of microwave oven, and set aside.
A
A. Blower screws (in recessed holes)
A
B
A. Blower motor wire
B. Connector
A
A. Blower Motor