Owner's Manual

7
A. End holes (on mounting plate)
B. Cabinet opening vertical
centerline
C. Wall stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers
Wall Stud at End Hole
Figure 3
D
A,D
B
C
C
E
E
F
A
Wall Studs at End Holes
Figure 4
A,D
B
E
A,D
C
E
C
F
Mark Upper Cabinet
Using measuring tape, nd and clearly mark the vertical
centerline of the opening. Make sure it is align with the
vertical wall centerline.
1.
A
B
A. Upper Cabinet Centerline
B. Wall Centerline
2a. Place the mounting plate against the bottom of the upper
cabinet.
NOTE:
A. Front Edge of Mounting Plate
& Front Edge of Upper Cabinet
B. Upper Cabinet Centerline
C. Mounting Plate Hooks
D. Center Marks on Mounting Plate
Make sure the front edge of the mouting plate align
with the front edge of upper cabinet.
Make sure the center marks on the mounting plate
align with the upper cabinet centerline which draw in
step 1.
Make sure the mounting plate hooks is facing out and
down.
•
•
•
Note: The metal mounting plate is t for depth of 12” to
12.75” cabinet installation, but need some adjustment for
for different depth. See the following steps 2a, 2b. For
cabinet depth of 12.75“ to 13”, follow the step 2c.
12.75" (32.4 cm) flush
12" (30.5 cm) min.***
13" (33 cm) max. ****
upper cabinet and
side cabinet depth
If you cabinet is 12.75” depth, follow the step 2a:
B
2b. Place the mounting plate against the bottom of the upper
cabinet.
NOTE:
A
C
A. Front Edge of Mounting Plate
& Front Edge of Upper Cabinet
B. Upper Cabinet Centerline
C. Mounting Plate Hooks
D. Center Marks on Mounting Plate
D
Make sure the front edge of the mounting plate align
with the back edge of upper cabinet.
Make sure the center marks on the mounting plate
align with the upper cabinet centerline which draw in
step 1.
Make sure the mounting plate hooks is facing out and
down.
•
•
•
If you cabinet is 12” to 12.75” depth, follow the step 2b:
B
A
C
D