ELECTRIC SELFCLEANINGSET-INUNIT WITHCONVERTIBLETOP - - Part No. 13199991868842 Rev.
FOR CUT-OUT DIMENSIONS SEE FRONT AND TOP VIEWS OF CABINETS BELOW. ELECTRIC SUPPLY JUNCTION BOX. LOCATE ON FLOOR OR ON WALL NEAR FLOOR LINE, IN ADJOINING CABINETS. CAUTION: To eliminate the hazard of reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage IS to be provided, the hazard can be reduced by lnstalllng a range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinet. ,-WALL LINE A 22-518” / .
. ELECTRICAL REQUIREMENTS OBSERVE ALL ORDINANCES GOVERNING CODES CAUTION: If connecting to a four-wire electrical system (mobile home) the appliance frame MUST NOT be connected to the neutral wire of the four-wire electrical system. Separate the white and green wires that extend out of the end of the supply cable of the appliance. Connect the white, red and black wires from the supply cable, matching the colors, to the corresponding wires in the junction box.
6. OVEN DOOR REMOVAL Lift the cooktop frame shown in Figure 5. up at the front and support Open Oven at sides, lift hinge arms in at bottom as Use the four mounting bracket holes in the hanger brackets as templates to locate the four appliance mounting screw holes. See Figure 5. TO Door to broil position. Grasp the door firmly up and away from the range. To replace, slip into door slots. With hand or knee, push door until it clicks. Then close door (see Figure 6). REMOVE I r FIGURE 6 7.