Installation Instructions
11
Adjust Oven Bake Burner Flame (if needed)
1. Check the oven bake burner for proper ame.
This ame should have a ½” (1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should
be clean and soft in character. No yellow tips, blowing or
lifting of ame should occur.
2. If the oven bake ame needs to be adjusted, locate the air
shutter near the center rear of the range. Loosen the locking
screw and rotate the air shutter until the proper ame
appears. Tighten locking screw.
3. Turn thermostat OFF when nished.
4. Reinstall ame spreader and oven bake burner cover.
Broiler Oven Drawer
The broiler oven drawer can be removed for easier Cleaning. To
remove:
1. Pull drawer out to the stop position.
2. Push up under the center of the drawer while pulling the
drawer out to allow the drawer stop to clear the range front
frame.
3. Drawer will slide out free of range.
NOTE : Do not use steel wool pads, commercial oven cleaner,
silicone oven sprays, coarse pads or coarse brushes on the
storage drawer.
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See the “Level Range” section.
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see
the “Range Care” section of the Use and Care Guide or User
Instructions.
6. Read the Use and Care Guide or User Instructions.
7. Turn on surface burners and oven. See the Use and Care
Guide or User Instructions for specic instruction on range
operation.
If range does not operate, check the following:
■ Household fuse is intact and tight, or circuit breaker has not
tripped.
■ Range is plugged into a grounded 3 prong outlet.
■ Electrical supply is connected.
■ See “Troubleshooting” in the Use and Care Guide or User
Instructions.
8. When the range has been on for 5 minutes, check for heat.
If the range is cold, turn off the range and check that the gas
supply line shutoff valve is open. See “Troubleshooting” in
the Use and Care Guide or User Instructions.
■ If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
■ If the gas supply line shutoff valve is open, turn knob to
OFF position. See “Troubleshooting” in the Use and Care
Guide or User Instructions.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or the cover of the User Instructions, or contact
the dealer from whom you purchased your range.
A
B
C
A. Locking screw
B. Air shutter
C. Flame
A
A. Drawer stop notch