Installation Instructions

13
To Convert Gas Pressure Regulator (Natural Gas to
Propane Gas)
1. Move the range to be able to work on the back of the unit.
2. Locate gas pressure regulator at top right corner of the back
of unit.
IMPORTANT: Do not remove the gas pressure regulator.
3. Remove the cap from the gas pressure regulator using a
7/8" (2.2 cm) wrench.
NOTE: Be sure sealing washer remains in the same position.
NOTE: Do not remove the spring beneath the cap.
4. To convert to propane gas, turn over the pin and place it
back on the cap.
5. Reinstall the cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Remove burner base.
3. Apply masking tape to the end of a
9
⁄
32
" (7 mm) nut driver to
help hold the gas orice spud in the nut driver while
changing it. Press nut driver down onto the gas orice spud
and remove by turning it counterclockwise and lifting out.
Set gas orice spud aside.
4. Remove the cardboard orice spud holder shipped in the
literature package in the oven. Gas orice spuds are
stamped with a number. Replace the Natural gas orice spud
with the correct Propane gas orice spud.
Refer to the following chart for correct Propane gas orice
spud placement.
Propane Gas Orice Spud Chart for Surface Burner
Burner Rating Size
14,000 BTU 1.10 mm
5,000 BTU 0.67 mm
8,000 BTU 0.83 mm
11,000 BTU 0.98 mm
NOTE: Refer to the Model Number and Serial Number Plate
located under the broiler carriage for proper sizing of spuds for
each burner location.
5. Place Natural gas orice spuds in the cardboard orice spud
holder.
6. Replace the burner base.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
A
A. Gas pressure regulator
A
C
B
A. Cap
B. Sealing washer
C. Pin
A
B
A. Burner cap
B. Burner base
B
A
C
A. Orice spud
B. Orice spud holder
C. Spark electrode
XX
A
A. Stamped number