Installation Instructions
16
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks.
2. The oven burner orice is located beneath the in-let to the
oven burner at the lower rear portion of the broiler section.
Using a 1/2" wrench turn the orice hood counter-clockwise
to fasten the hood off the orice pin about two complete
turns.
NOTE: Do not over-tighten the orice hood.
Complete Installation (Propane Gas to Natural Gas)
1. Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop and oven burner ame is very
important. Natural gas ames do not have yellow tips.
2. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
NOTE: Save the orices removed from the appliance for
future use.
3. After the above conversion has been completed, check
operation of cooktop and oven burner. Make air shutter
adjustments in oven if necessary.
Adjust Air Shutters
The air shutter adjustment for the oven burner is located at the
open end of the oven burner venture tube and sits on the hood
of the oven burner valve. To adjust air shutter:
1. Loosen the screw on the air shutter.
2. Move the air shutter closed to decrease or open to in- crease
the amount of air to the ame.
3. When the ame is properly adjusted, tighten the screw.
NOTE: The burner ame should be a steady blue. A burner
with a yellow ame, un-steady ame, or a partial ame is in
need of an air shutter adjustment.
Orifice Hood
Propane Gas
Natural Gas
Pin