AIR CONDITIONER 1187361 Use & Care Guide

Install in window

1. From inside, place SMART-MOUNT

™

tray, support legs facing

down, in the window. Match the holes in tray side with the

predrilled holes in windowsill.

2. Using 2 - #10 - 12 x 1¹⁄₂ in. slot-head wood screws, secure

the tray-frame assembly to the window.

NOTE: If the exterior of building can be damaged by support

legs, place a board between the wall and support legs.

3. With tray center pushed away from the windowsill, place a

level on the angled edge of tray side. Check to be sure level is

against notch on tray side. Adjust SMART-MOUNT

™

tray until

bubble indicates level.

4. Tighten the hex nut just enough to hold tray center in place.

5. Repeat with other side.

6. Tighten hex nuts securely with ⁷⁄₁₆ in. wrench.

Prepare Air Conditioner for Installation

1. Locate provided bag of pan-head screws.

2. Place the top channel on top of the air conditioner, lining up

the holes in top channel with the holes on top of air

conditioner.

3. Using 3 - #10 x ³⁄₈ in. pan-head screws, attach top channel to

air conditioner.

Install side curtains

NOTE: Attach curtains to unit before placing unit in window.

1. Insert curtain into curtain frame. Make sure the curtain end

locks into curtain frame.

2. Push curtain in all the way.

1. #10 - 12 x 1

¹⁄₂

in. slot-head wood screws

1. Place level on angled edge

against notch on tray side

1. Top channel

2. #10 x

³⁄₈

in. pan-head screw