Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 1 of 20
European Touch - Limited Warranty EUROPEAN TOUCH manufactures the Platino ® Whirlpool Pedicure Spa with the highest standards for quality materials and workmanship accordingly; EUROPEAN TOUCH expressly warrants their products as follows: To the original ow ner of the Platino ® Whirlpool Pedicure Spa (herein called "pedicure spa"): EUROPEAN TOUCH may repair or exchange at its option, any pedicure spa found to be defective in material or workmanship upon inspection by an authorized representative of EUROPEAN
Certificate of Compliance For European Touch 8301 W. Parkland Court M ilwaukee, WI U.S.A. 53223 For Compliance of: Equipment: Whirlpool Pedicure Spa Model No.: PLATINO Rated: 220-240VAC, 50Hz, 7.5A To the following standard(s): EN 60335-1:2002 EN 60335-2-32:2002 EN 55014-1 (Generic): 2001 EN 55014-2 (Generic): 2003 EN 61000-4-2 (Criteria C): 2001 EN 61000-4-3:2002 EN 61000-4-4: 1995 EN 61000-4-5: 2001 EN 610004-6: 2001 EN 61000-4-11: 2004 Project No.
OWNERS MANUAL For Platino® Whirlpool Pedicure Spa Important Information Serial Number: Work Order Number: Installed by: Installation Date: The serial number and work order number are located under the seat bottom cushion on the seat track plate. Remove seat bottom cushion to locate the serial number and work order number located on seat frame. Note: Vietnamese and Korean translations available upon request.
Table of Contents European Touch - Limited Warranty .........................................................................2 Certificate of Compliance ..........................................................................................3 Important Information ................................................................................................4 Introduction ................................................................................................................
Introduction Thank you for selecting EUROPEA N TOUCH, the leading designer, manufacturer, and marketer of pedicure spas in North America. The Platino® Whirlpool Pedicure Spa (herein referred to as pedicure spa) is an innovative w hirlpool pedicure spa that has been designed to serve you dependably for many years. Please take time to thoroughly read this entire manual before installation and use.
Installation Specifications Summary Note: Failure to comply with federal, state or local codes and ordinances will result in warranty being null and void. As stated, the pedicure spa installation must comply w ith all plumbing and electrical codes. A licensed plumber and licensed electrician must complete the applicable connections of the pedicure spa. Location and Support Select a level location. The floor structure beneath the pedicure spa must be capable of supporting the occupied pedicure spa.
Important Installation and Utility Information Electrical Service: 110V: 110V, 60 Hz, 2.75 A mp GFCI protected grounded circuit must be used to supply pow er to the pedicure spa. (220V if ordered in 220V configuration) 220V: 220V, 50/60 Hz, 2.75 Amp GFCI protected grounded circuit must be used to supply pow er to the pedicure spa. Water Supply: All plumbing connections must conform to local codes. Nor mal w ater pressure of 30 to 80 PSI is required to correctly fill the basin to the proper level.
Dimensional Drawings Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 9 of 20
Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 10 of 20
Pedicure Spa Specifications *Hot and cold w ater supply lines required (hot and cold shut offs may be installed under pedicure spa base) *Drain installation: References noted on page 9, standard unit comes w ith drain pump.
Attaching the Seat Back and Seat Bottom Cushion Your pedicure spa shipped with the seat back already attached to the spa and with the seat bottom cushion in the spa shipping box. Follow these instructions to connect the seat back and the seat bottom to the pedicure spa: Seat Back Attachment Seat Bottom Attachment Step 1: The seat bottom cushion will be located in the spa on top of the spa basin. Remove the seat bottom cushion from the spa basin.
Installing and Removing the Side Panels To install the side panels on your spa follow the instructions below: Step 1: Slightly lift side panel into place on spa frame. Step 3: Make certain that the side panels lay above the frame at the top of the basin, as shown above. Step 5: Align the thumbscrew holes located under cushion skirt, and screw in the thumbscrew. Step 2: Align the magnets on the frame legs with matching brackets found on the inside of the side panel. There is one set on each leg.
Remote Control Configurations Roller Massage function LEDs indicate Roller feature is activated and amount of time activated Recline Seat Back : Tilt backward or forward LED indicates Heat is On LEDs indicate Vibration feature is activated Turns Heat On/Off Move Seat Bottom: Forward or Backward.
Component Reference Pipe-Free Inside Basin View Pipe-Free Front View Pedicure Product Guidelines Because there are so many different products on the mar ket, it is difficult to list all of the pedicure products that are safe to use in our pedicure spas. How ever, the follow ing guidelines can be used: • • • • • It is your responsibility to understand and follow your state’s regulations regarding product cleaning and disinfecting requirements.
Crystal Clean™ Pipe-Free® Spa - Operating Instructions Preparing the Pedicure Spa for Operation: After the pedicure spa is installed and the plumbing and electrical connections are made, clean and disinfect the basin before initial use. Rinse the basin by using the attached w ater sprayer. Wipe the basin dry with a clean tow el. To Operate the Pedicure Spa, Follow These Easy Steps: Adding Water to the Pedicure Spa Basin: 1.
Crystal Clean™ Pipe-Free® Spa - Cleaning and Disinfecting Procedures Please check with your state board for required cleaning and disinfecting procedures. It is extremely important to clean and disinfect your pedicure spa after each pedicure, after the last pedicure of the day, and once a week for ov ernight cleaning. Regular cleaning will help keep your pedicure spa in good working condition. Proper and continuous cleaning will kill harmful bacteria and germs that can cause infection.
Removing / Replacing Drain Handle Tools needed: Phillips head screwdriv er Check y our state and local regulations for cleaning procedures. Links to y our state boards can be f ound on our web site, at ® www.europeantouch.com. Ref er to the cleaning procedure page headed “Crystal Clean™ Pipe-Free Spa - Cleaning and Disinf ecting Procedures,” page 17. Follow the steps below for cleaning and replacing parts.
History and Notes Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 19 of 20
EUROPEAN TOUCH 8301 W. Parkland Court Milwaukee, WI 53223 Phone Number: Toll Free: Fax: Web Site: Email: 414-357-7016 800-626-6912 414-357-6360 www.europeantouch.com info@europeantouch.