Installation Instructions

6
Locate Wall Stud(s)
NOTE: If no wall studs exist within the cabinet opening,
do not install the microwave oven.
See illustrations in the “Possible Wall Stud Configurations”
section.
1. Using a stud finder, locate the edges of the wall stud(s)
within the opening.
2. Mark the center of each stud, and draw a plumb line
down each stud center. See illustrations in the “Possible
Wall Stud Configurations” section.
Possible Wall Stud Configurations
These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at End Holes
Figure 1
No Wall Studs at End Holes
Figure 2
NOTE: If wall stud is within 6" (15.2 cm) of the vertical centerline
(see the “Mark Rear Wall” section), only recirculation or roof
venting installation can be done.
Wall Stud at One End Hole
Figure 3
Wall Studs at Both End Holes
Figure 4
A
A
B
C
C
D
E
E
F
A
A
B
C
D
E
E
F
A
A,
D
B
C
C
D
E
E
F
A,
D
B
E
A,
D
C
E
C
F
A. End holes (on mounting plate)
B. Cabinet opening vertical centerline
C. Wall stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers