Installation guide

INSTALLATIONREQUIREMENTS
ToolsandParts
Gather the required tools and parts before starting installation.
The parts supplied are inthe washer basket.
Tools needed for connecting the drain hose and water
inlet hoses:
• Pliersthatopento 1_8" • Flashlight(optional)
(3.95 cm)
Parts supplied:
Alternate Parts
Your installation may require additional parts, For ordering
information, please refer to the toll free phone numbers on the
front page of your "Washer User Instructions,"
If You Have: You Will Need to Buy:.
Laundry tub or
standpipe taller
than 96" (2.4 m)
Sump pump system (if nat already
available)
A B
0
A. Drain hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
C
Tools needed for securing the drain hose and leveling
the washen.
• Adjustableoropen end • Woodblock
wrenchHe" (14 mm) • Rulerormeasuringtape
• Level
Parts supplied:
A B
A. Beaded tie strap
B. Front leveling feet with nuts (2)
1" (2.5 cro) 2" (5 cm) diameter to 1" (2.5 cm)
diameter diameter standpipe adapter,
standpipe Part Number 3363920
Overhead sewer Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Floor drain Siphon break, Part Number 285320;
additional drain hose,
Part Number 3357090 and connector kit,
Part Number 285442
Water faucets 2 longer water fill hoses:
beyond reach offill 6 fl (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008
Drain hose too Drain hose, Part Number 388423 and
short hose kit, Part Number 285442
Drain hose that is Hose kit, Part Number 285442
too long
Lint clogged drain Drain protector, Part Number 367031
2