Installation guide

CONNECT INLET HOSES

Washer must be connected to water faucets with new inlet

hoses with flat washers (provided). Do not use old hoses.

NOTE: Both hoses must be attached and have water flowing

to inlet valves. If you are only connecting to a cold water

faucet, you must use a Y-adapter (provided).

If you have a hot water faucet, go to step 8a.

If you have only a cold water faucet, go to step 8b.

Connect inlet hoses to

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use pliers to tighten couplings an

additional two-thirds turn. Repeat this step with second hose

for cold water faucet.

iMPORTANT: Do not overtighten or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.

Attach the brass female end of the "Y"

connector to the cold water faucet. Use pliers

to tighten couplings an additional two-thirds turn. One end of

the long hose has a wire mesh strainer inside the coupling.

Attach this end to the "Y" connector. Attach washer cold inlet

hose to other side of "Y" connector. Screw on coupling by

hand until it is seated on connector. Using pliers, tighten the

couplings an additional two-thirds turn.

iMPORTANT: Do not overtighten or use tape or sealants

on valve when attaching to faucets or washer. Damage

can result.

Clear water lines

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to avoid clogs. Water should run until clear.

Make note of which hose is connected to hot water to help in

attaching hoses to washer correctly.

f0, Connect inlet hoses to washer

#0¢_' ¢@Li#

Attach hot water hose to hot water inlet valve marked with a

red ring. Screw coupling by hand until it is snug. Use pliers to

tighten couplings an additional two-thirds turn. Repeat with

cold water inlet valve.

iMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates

for future reference.

[] Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.