Instruction for Use

25
TROUBLESHOOTING GUIDE
Oven not working:
_
Check for the presence of mains electrical power
and if the oven is connected to the electrical
supply.
_
Turn off the oven and restart it to see if the fault
persists.
The door is locked and will not release:
_
Turn off the oven and restart it to see if the fault
persists.
IMPORTANT:
_
Check that the oven control knob is not turned
to “0” or to “lamp” .
If the electronic programmer (depending on
model) display presents the message
“ ”, consult the product description
sheet provided separately and/or the
electronic programmer description.
- If the electronic programmer (depending on
the model) presents the message “
.::
”,
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter “
.
”.
AFTER SALES SERVICE
Before you call the After Sales Service
1.
Try to solve the problem yourself following
the points described in “Troubleshooting
Guide”.
2.
Turn the appliance off and on again, to make
sure that the problem has been solved.
If after the above checks the fault still occurs,
get in touch with the nearest After Sales
Service.
Please give:
_
a short description of the fault;
_
the oven type and model;
_
the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet;
_
your full address;
_
your telephone number.
If any repairs are required, please contact an
authorised After Sales Service
(to guarantee
that original spare parts will be used and repairs
carried out correctly).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
_
This oven is designed to come into contact with
food and complies with regulation (EC)
no.1935/2004.
_
It is designed to be used only as a cooking
appliance. Any other use (e.g. for heating rooms)
is deemed improper and therefore dangerous.
_
This appliance has been designed, manufactured
and put on the market in compliance with:
- the safety requirements of “Low Voltage”
Directive 2006/95/EC (replacing 73/23 EEC
as amended).
- the protection requirements of “EMC”
Directive 89/336/EEC.
- the requirements of Directive 93/68/EEC.
61056197.book Page 25 Friday, May 11, 2007 2:43 PM