Troubleshooting guide

11
GUIDE TO SELECTING FUNCTIONS
Stand-by
This function turns off the refrigerator and freezer compartments. To activate the standby function, press
the button for 3 seconds: both displays will go off and a dash will appear on the left display. To reset the
function, carry out the same procedure until the previously set temperatures are displayed.
Note: Remember that this operation does not disconnect the appliance from the power supply.
Freezer temperature
The factory-set ideal temperature is -18°C. As soon as the freezer compartment reaches the required
temperature, it is automatically displayed.
To change the temperature, press the buttons until the display shows the required value.
Refrigerator temperature
The factory-set ideal temperature is +5°C.
To change the temperature, press the buttons until reaching the required value that it will be
displayed.
Ice On/Off
To switch the ice maker on press the on-off button until one of the two icons comes on .
To deactivate the function, repeat the procedure until both icons go off.
Ice mode
This function enables to select the type of ice desired: crushed ice or ice cubes . For further
information refer to the section “Using the ice and water dispenser” section.
Ice and water dispenser light
The light can be switched on and off by pressing the button on the control panel or pressing one of
the two dispenser levers; the light will switch off automatically once the water or ice has been dispensed.
USING THE APPLIANCE
501931502018_GB 18-06-2007 14:56 Pagina 11