Ice Maker User Manual

ManualsBrandsWhirlpool ManualsIce Maker2180911

IMPORTANT:

Read and save

these instructions.

IMPORTANT:

Installer: Leave Installation Instructions

with the homeowner.

Homeowner: Keep Installation Instructions

for future reference.

Save

Installation Instructions for local

electrical inspector’s use.

Automatic

Ice Maker

Part No. 2180911

Summary of content (5 pages)

PAGE 1
u IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. Automatic Ice Maker Part No.
PAGE 2
Before you start... Drain system requires either a gravity floor-drain system or a drain pump (see “Drain requirements”) to lift the water to an existing drain. A l-l /4” minimum diameter standpipe or 5/8” I.D. minimum drain tube to an open drain is required. Commercial installation sanitation codes: National Sanitation Foundation (NSF) installation procedures require sealing the ice maker to the floor with approved caulking compound. We recommend using a silicone-type sealer.
PAGE 3
Electrical requirements Water requirements screw . The cold water line to the ice maker must be l/4” O.D. soft copper tubing. Use the threaded compression fitting to connect the water line to the ice maker inlet valve. Install a shutoff valve in the water line where it can be easy to access Preparation steps: 1aPut on safety glasses and gloves. 2. Cut a l/2” minimum hole in cabinet wall or floor for water line. Right side of wall is easiest location. 3.
PAGE 4
12 Changing the bin door and lower panel 13 The bin door and lower panel can be customized to match wood cabinets. Check your type of ice maker (Model A or B) to determine the height needed for the bin door. Only those models with a solid lower panel and toe space grille can be fitted with a lower wood panel. l Cut panels using the specified dimensions. l Make sure wood grain matches the direction of cabinet wood grain. l The ice maker is subject to some humidity.
PAGE 5
If the ice maker does not operate: If you need assistance: 4 Check that the circuit breaker is not tripped or the house fuse is intact and tight. 4 Check that the power supply cord is plugged into the wall receptacle. 4 Check that the water line is turned on. 4 See the Use and Care Guide troubleshooting list. If you have questions about operating, cleaning or maintaining your ice maker: 4 Refer to the Use and Care Guide. 4 Call the dealer from whom you purchased this ice maker.