COMPACT DRYER 240 VOLT .
Before you start.. . Important. Check locoi~on where dryer will be llstalled Proper instollat~on IS youi responslbllity Make sure you have everyihing necessary for correcl mtollol~on observe WARNING: Check code requirements. all governrng codes and ordinances. Potential Fire Hazard Some codes do not perml or limit ~nslollai~on of clothes dryers ln garages. closets. moblle homes.
Electrical requirements Electrical ground is required on this appliance. upturned ends on dryer end. terminahng I” a NEMA Tvpe 14.
cord hole TIghten condull conneciorto cabsnet Inseri power supply cable through conduit connector 3. Connect the neutral wire of the flexlole armored or nonmetalllc sheathed copper power supply cable to the center, silver-colored termlnol of the temxnol block Connect the other wires to the outer terminals See Figure 8 For connecting plan-end wires. see “Direct wire connectlon:’ Panel Et 4. Replace the terminal block cover 4.
Recessed area or ‘closet installation ns~~~” IIYl.-nll”“.31cI ,II~,V,.“..“.. . ..“<. ,.I. use only the rear exhaust position and Exhaust Detlector Kit, Part No. 3460M is required. --t Recessed This dryer may be Installed in a recessed area or closet. The installation spacing is in inches and is minimum allowable. Additional spacing should be considered for ease of installation and servicing. If o closet door is installed, the minimum unobstructed air openings in top and bottom are required.