IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for electrical inspector’s use.
Before you start... Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the clearances specified. Check the location where the range hood will be installed. The location should be away from strong draft areas, such as windows, doors, and strong heating vents. Electrical Shock Hazard It is the customer’s responsibility: To contact a qualified electrical installer.
Now start... Venting requirements With range hood in kitchen. round ductwork Property Damage Slide cardboard or hardboard under range before moving range across floor. Failure to do so could cause damage to floor covering. Cover countertop, cooktop or set-in range with a thick, protective covering. Failure to do so may result in property damage. elbow Fire Hazard Terminate venting system to outside. . Do Not terminate the vent in an atlic or other enclosed space.
7. terminal bOX cover 6 m Remove terminal box Cover from Mae than one person is required to help with appliance intiallation because Of its weight and size. Failure to tallow these instructions may result in personal injury. Numbers correspond to steps.
Non-vented installation _. !&wlA II If\1 green grounding screw I I I Check vent baffle on top of range hood. “Non-vented” should be facing up. Remove terminal box cover. Connect the white and black wires of the power supply cable to the white and black leads in the hood with twist-on connectors, Connect the power supply grounding wire to the green, grounding wire inside the range terminal box with a twist-on wire connector. Use caulking to seal wire opening. Replace terminal box cover. 2.
Operation of range hood Use & Care Information For best results, turn range hood fan ON at beginning of cooking and allow it to run until all smoke and odors ore removed from room. To turn fan ON, HIGH and LOW: Turn fan control to turn fan to HIGH, LOW and OFF. Speed may be increased or decreased any-time during range hood operation. To turn range hood light ON and OFF: Turn light control to turn light ON or OFF. Light may be turned to OFF or ON anytime during range hood operation.
If range hood does not operate... If you need assistance... Check that the circuit breaker is not tripped or the house fuse blown. The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining your range hood not covered in the Installation Instructions. The Whirlpool Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial l-(800) 253-1301 -the call is free. When you call, you will need the range hood model number and serial number.