Part No. 3354199 Rev A COMMERCIAL WASHER IMPORTANT Installer: Leave Installation 7 I I ~ 1 120volt, 60 Hz Models 1 lnstructlons with the owner. Owner: Keep lnstallatlon Instructions for future reference. Save Installation Instructions for local electrtcal Inspector’s use.
Before you start.. . Coin-operated washers are equipped with a meter case, console, timer, selector switches and indicator lights. The coin slide mechanism, slide mounting bolt, slide extension, service door panel lock and key, top lock and key, coin vault, and coin vault lock and key are not included with this washer and are needed to complete installation. These items are available from usual industry sources. Check location where washer will be installed.
TooIs needed for instaIIation: Electrical requirements l l l l Parts supplied for fnstalIation: l l Remove parts from packages, that all parts were included. 1 hose clamp 2 inlet hoses 4 flat water hose washers 2 front leveling legs with nuts grounding clamp and screw 1 drain hose PAGE2 Check Electrical Shock Hazard Electrical ground is required on this product. Improper connection of the equipment-groundtng conductor can result in electrical shock.
end is held tightly over edge of standpipe. If drain hose is to long - cut straight end of hose. (Do /&z,ut “hook” shaped end of drain DO NOT FORCE DfCESS LENGTH OF DRAIN HOSE DOWN THESTANDPIPE. THIS COULD CAUSE SIPHONING. the other end of the shipping strap from the back of the washer. The shipping strap plug must be completely removed from the washer forthe self-leveling legs to be released. Discard shipping strap. Carefully tilt washer backward until front of washer is 3-4 inches off of floor.
Rotate counterclockwise only . ‘3 \: ‘6 0 lm _ w I level, screw the front legs up or down to adjust. Make final check with level. When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate. 19 Check that all parts are w now installed. See parts list, Page 2. If there is an extra part, go back through steps to see which step was skipped. 20 21 + l Turn on water faucets W and check for leaks.
Owner options (coin operated models) CAUTION: Disconnect power cord. 1. For EXTRA SPIN - 2 minutes. l Remove meter case service door. l Loosen (2) screws on the timer mounting bracket and lift the timer out. Mixed Load l Connect BK to BK2 2. For WARM RINSE and WATERSAVER: l Remove screws from each end of the console bottom. l Pull the console bottom forward; lift and tilt it back. a. WARM RINSE l Connect Jl to J2. b. SAVE WATER l Pull out tab on water-level switch. 3.
rynrm -- l 1 feet PAGE 6 I
CORPORATION Part No. 3354199 Rev. A Q 1990 Whirlpool Corporation Prepared by Whirlpool Corporation. Benton Harbor. Michigan 49022 Printed In U.S.A.