Installation Instructions Part No. 3360620 IMPORTANT: Read and save these instructions IMPORTANT Installer: Leave Installation Instructions with the owner. Owner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. www.whirlpool.
Before you start... Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”. These words mean: Check location where washer will be installed.
Tools needed for installation: level Electrical requirements Recommended ground method WARNING pliers Electrical Shock Hazard Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock.
Now start... Inlets are plastic. Do Not strip or crossthread. With washer in laundry area. WARNING Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. 6. Measure and mark a point approximately 16 inches from the plug end of the shipping strap. Cut this shipping strap at this point. 3. Attach hose to bottom inlet valve opening first. Then second hose to top inlet.
12. Tilt washer backward and remove corner posts. Gently lower washer to floor. Move washer to its permanent location. Remove cardboard or hardboard from under washer. Rotate counterclockwise only. 18. CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE CORRECT ELECTRICAL SUPPLY AND RECOMMENDED GROUNDING METHOD. timer “off” position timer-front view e ns ain Dr cycle information in Turn on water faucets and check for leaks. Tighten couplings if there is leaking.
Owner options (coinoperated models) CAUTION: Disconnect power cord. 1. For EXTRA SPIN and/or EXTRA WASH. • Remove meter case service door • Loosen (2) screws on the timer mounting bracket and lift the timer out. (2) screws a. EXTRA WASH — 3 minutes. • Connect LBU to LBU2. • Disconnect GY from GY2. • Set timer clutch arm as shown below. Extra Wash Standard Wash Leave “⊥” on timer shaft aligned with “⊥” on timer and move timer clutch arm to “extra” wash position. b. EXTRA SPIN — 2 minutes.
" power cord cold 1-1/2" hot 43" water Inlets 38-1/8" 35" drain hose connector 27-3/4" 7" 25-1/2" 5" 5-1/4" 1" PAGE 7 27"
Part No. 3360620 ©1999 Whirlpool Corporation Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022 Printed in U.S.A.