Part No. 3374369 IMPORTANT: Read and save these instructions.
Before you start... Proper electrical, drain and water supply lines must be available or must be installed as specified within shaded area. Plumbing and wiring should not cross in front of motor or dishwasher legs. See Electrical, Water and Drain requirements. Proper installation is your responsibility. Make sure you have everything necessary for correct installation.
Water Requirements Now start... ove 4 screws. with dishwasher in kitchen. The hot water line to the dishwasher must provide between 15 - 120 psi water pressure. The hot water heater should be set to deliver 140°F water temperature to the dishwasher for best results. 7i Use 3/8” O.D. copper tubing or l/2” plastic tubing minimum inlet line. Dishwasher inlet valve has 3/8” N.P.T. internal pipe thread.
Alternate drain hose connection methods: Recommended drain hose connection methods: Drain hose to air gap to waste tee. air-gap Tilt dishwasher backwards on wheels when moving across floor. Failure to do so may cause damage to floor covering. kit Drain hose to waste tee. to fit. waste tee < - rubber connect0 20” clearance to floor waste tee < mrnrmum clearance to floor 8 B Latch dishwasher door. Push dishwasher into place, sliding drain hose through hole cut in cabinet opening.
j equally space* Product Damage Do Not solder within 6” of plastic water inlet valves. Failure to follow this instruction could result in product damage. To change door panel color NOTE: The opposite side of the door color panel is a different color. 14 w Open door approximately 3” and check for equal spacing between inner door and tub sides. If necessary, loosen screws that fasten dishwasher to countertop and shift tub. Tighten screws. Personal Wear gloves and carefully.
To change access color panel top of panel under control console This panel is narrower than access panel. (For models so equipped) Personal Wear gloves and carefully. Cut metal edges injury or damage File or sand edges of ;~;oye’ Injury Hazard handle panels slivers. may cause personal to other materials. n Insert top of wood door panel between sides’of door frame about 3” below console. Rotate wood door panel down against dishwasher door.
If the dishwasher Is not operating properly.. . Check these points: Is the door closed tightly and latched securely? l Has the cycle been set correctly to start the dishwasher? l Is the water turned on? l Has a house fuse blown or circuit breaker tripped? l Has electrical power been interrupted? Note: If the motor has stopped because of overload, it will automatically reset itself within a few minutes. If after checking these points the dishwasher still does not run or complete a cycle, call for service.