Specifications
control console
control console,
allowing panel(s) to
rest on channel at
bottom of door.
Into channel.
spacer /
Push In
along
6
n
Snap one end of retainer into
channel ‘as shown. Push inward
while sliding thumb along full length
of retainer.
To change access
color panel
(For models so equipped)
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may cause serious injury.
1
n
Push up
with thumbs on
each end of
access panel
top trim to
unsnap trim.
Remove top trim and set it aside.
2
n
Carefully
slide color
access panel
upwards and
remove.
Do Not
remove spacer.
3
n
With
desired color
facing out,
bow access
panel and
insert it into
access panel frame. Slide panel
down into groove along bottom of
access panel frame.
$$yF& L/
w
. .
of access
--..
oanel frame.
Tilt back of trim -
down and slide into place. Snap
front of trim down to cover top
edge of access panel.
Parts that must
be custom made
Maximum custom door panel
weight
is 4
pound (1.8 kg).
Dishwasher door panel and access
panel (if model is so equipped) can
be customized to match wood
cabinets. A standard, l/4”* wood
panel can be used as is for
customizing the door and access
panels. It is recommended that a
cabinetmaker cut the customized
panel pieces because of the
precise dimensions needed.
l
Cut wood panels so that wood
grain matches direction of grain in
cabinets.
l
File or sand edges of wood
panels.
l
Dishwasher is subject to some
humidity. Apply moisture-resistant
sealer to both sides and edges of
wood panels.
l
7/32” (0.56 cm) actual
thickness.
Custom
door and access
panels
The custom door panel must not
weigh more than 4 pounds
(1.8 kg).
Cut door panel accurately for a
snug fit between door side frames.
Note: Custom door panel fits
between, Not inside frame.
7/X!” (0.56 cm) thickness
-1
Page 10