Specifications

Custom panel dimensions
Note: This panel Is narrower than access
panel.
File or sand edges of wood panel to
avoid slivers.
door panel
side view
top e
(0.
-D
(0.
b#
i
dgeJ
,S6 cn
7132
56Cll
ottom
adge
‘132”
;
3/v
F
(0.95 cm)
L
5
(2.5 cm)
1)
I
door panel
front view
23” (58.4 cm)
access panel
- 23-S/16” (59.2 cm)
Routing custom panels
side view
A lrdoor
closed
/ door ‘I ti
clear access panel
when door is In
door
‘pivot
access
panel
open position.
, .
7132”
top view (0.56 cm) thick
(0.64 cm)
min.
Custom door panel more than 7/32”
(0.56 cm) thick: Route top and
bottom to 7/32” (0.56 cm) thickness.
Custom access panel more than
7/32” (0.56 cm) thick: Route all four
sides to 7/32” (0.56 cm) thickness.
Custom panels less than 7/32”
(0.56 cm) thick: Install spacers
behind panels.
To install
customized wood
panels in door
and access panel
1
n Cut wood door and access
panels using specified dimensions.
Make sure wood grain direction
matches cabinet wood grain.
2 n File or sand edges of wood
panels to avoid slivers.
Dlshwasher is subject to some
humldlty. Cover both sides and
edges of wood panels with
moisture-resistant sealer.
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may cause serious injury.
3
n Insert
finger under one
end of retainer
and pull towards
you in a peeling
action. Set
retainer aside.
4 n Lift door
panel(s) at outer
edges. Use one
po;;EogoW
panel(s). Remove
panel(s) and
spacer. Save
panel(s) and
spacer for future use.
All edges routed to 7132” (0.56 cm)
thickness.
Note: This panel is wider than the door
wnel.
Page 11