Specifications

ins
be
sid
not inside, door frame
n Insert top of wood door
panel between sides of door frame
about 3” (7.5 cm) below console.
Rotate wood door panel down
against dishwasher door, Slide top
edge of wood door panel under
bottom edge of console. Press lower
portion of wood door panel in
place between sides of door frame,
allowing wood door panel to rest on
channel at bottom
Push in
along length
ot retainer.
6
n Snap one end of retainer into
channel as shown. Push inward
while sliding thumb along full length
of retainer.
Part No. 3380268
01996
1 w Check door for proper
operation. Door should close easily
without slamming and open with its
own weight. If necessary, close door
and adjust both door springs by
moving spring ends to different
holes in base.
8 n Push
up with
thumbs on
each end
of access
panel top
trim to
unsnap
trim. Remove top trim and set it aside.
9
Cartfully slide
color access
panel and
spacer upwards
and remove.
Save color access panel and
spacer for future use.
10
n Insert wood access oanel
into access panel frame. Slide panel
down into groove along bottom of
access panel frame. It may be
necessary to remove the two screws
securing top of access panel to
dishwasher frame and tilt access
panel forward to install some wood
panels.
11 n Line
up edges of
top trim with
sides of access
panel frame. Tilt
back of trim
down and slide
into place. Snap front of trim down
to cover top edge of wood access
panel.
Benton Harbor, Michigan 49022
On models equipped with tub collar
To replace tub collar...
If dishwasher is moved and the new
cabinet opening is 24 inches (61 cm)
or more, follow Installation Instructions
until dishwasher is to be centered and
leveled in cabinet opening. Align
center of tub collar with latch area at
the top of the dishwasher tub. Snap
tub collar evenly over top and side
edges of dishwasher tub. Check that
tub collar is securely
attached to
dishwasher.
Continue
to install tub
your
colla
dishwasher
using the
Installation
Instructions.
If the
dishwasher is
not operating
properly.. .
Check these points:
l Is the door closed tightly and
latched securely?
l Has the cycle been set correctly to
start the dishwasher?
l Is the water supply turned on?
l Has the electrical power been
connected?
l Has the circuit breaker been
tripped or the house fuse blown?
l Has electrical power been
interrupted?
Note: If the motor is stopped
because of overload, it will
automatically reset itself within a few
minutes. If after checking these
points the dishwasher still does not
run or complete a cycle, call for
service.
If you need
assistance...
Call your dealer or authorized repair
service.
When you call, you will need the
dishwasher model number and
serial number. Both numbers can be
found on the model/serial rating
plate behind the dishwasher door
on the front frame.
Printed in U.S.A.