Specifications

R
4 w Check that front leveling legs
are firmly against the floor. Align
dishwasher door with cabinet doors,
so that spacing is the same on both
sides.
Tip Over Hazard
Do not use dishwasher until
completely installed.
Do not push down on open
door.
Doing so can result in serious
5
n Open
dishwasher door
and remove all
shipping
materials.
Remove bottom
rack. Place a
newspaper, large
sheet of paper or a towel over
bottom of dishwasher to prevent
screws or other items from
dropping into the pump area
when securing dishwasher to
countertop.
screivs No. 10 x l/2”
Do Not drop screws
into tub.
6
n The dishwasher must be
secured to countertop to prevent
tipping when dishwasher door is
opened.
Secure dishwasher to countertop
with Iwo No. 10 x l/2” Phillips-head
screws from parts bag.
eaual
7
n Open dishwasher door
approximately 3” (8 cm) and check
for equal spacing between inner
door and tub sides. If necessary,
loosen screws that fasten
dishwasher to countertop and shift
tub. Tighten screws. Remove
newspaper or towel from bottom of
dishwasher.
,yzeer inlet
8
n Connect water pipe or tubing
directly to water inlet valve.
Do Not allow pipe or tubing to cross
in front of or contact dishwasher
motor or legs. Turn water supply on
and check for leaks.
You may
have fhls
type drain
connector
or this type.
9 n Put spring-type drain hose
clamp over connector. Push drain
hose onto connector. Use pliers to
open clamp over drain hose and
connector. Check that drain hose is
secure.
If screw-type clamp is used instead
of spring-type clamp, use a 5116”
nut driver to tighten drain hose
securely to connector.
To minimize noise and vibration,
route drain hose to avoid contact
with door springs, motor, water line,
cabinet or flooring. Do Not run drain
hose over top of tub.
10 # If color oanel is to be
changed or c&om panels installed,
change panels now. See “To
change door panel color” and “To
change access panel color”
sections, Pages 9-l 2.
11 .
Check dishwasher door for proper
operation. Door should close easily
without slamming and should not
fall open or shut from its own weight.
If necessary, close door and adjust
both door springs by moving end of
springs to different slots in the
dishwasher base.
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green
ground connector in terminal box.
Do not use an extension cord.
Failure to do so can result in
death, fire, or electrical shock.
12
I
H Make electrical
connection. See “Wiring methods,” connection. See “Wlrlng melrioas,’
_--.- ~.
Page 4. CHECK ELECTRICAL
REQUIREMENTS. BE SURE YOU HAVE
U HAVE
. .--.
THE CORRECT ELECTRICAL SUPPLY
.Y
AND RECOMMENDED GROUND ‘ND
METHOD. Check that all parts have
been installed, and that no steps
were skipped. Check that no screws
have fallen into the tub. Reinstall
rack in dishwasher. Turn on electrical
and water supplies.
13
n Take a few minutes to read
the Use and Care Guide to fully
understand your new dishwasher.
Start dishwasher and allow it to
complete a full wash cycle. Check
that dishwasher is working properly
and that there are no leaks. When
dishwasher stops, open door and
check for proper draining.
Page 8