Specifications

Numbers
__-_._--.-
correspond to
installation steps.
(6.
0
Connect to
gaNs
disposer
connector.
\
drain hose
shipped
41
inside tub
Door, racks,
access and
gn;; not
Cut here to
connect to
waste tee of
air gap.
Electrical Shock Hazard
Reinstall ground clip over edge of
access panel.
Attach toe panel, access panel and
ground clip tightly to dishwasher leg.
Failure to do so may result in
death or electrical shock.
Make sure this clip stays
14
attached to access panel.
n Reattach the toe panel and
access panel. Check that ground clip
is attached to the access paneLThe
bottom edge of toe panel must be
positioned to contact floor.
15
n If dishwasher is equipped
with a flexible insulating strip at the
bottom of the door, check that the
flexible insulating strip overlaps the
upper edge of the access panel
before attaching access panel.
You have just finished
installing your new
undercounter dishwasher.
Keep Installation Instructions
available for easy reference.
To change door
panel color
Note: The opposite side of the
g,;rcolor panel is a different
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may cause serious injury.
1
a Insert
finger under
one end of
retainer and
pull towards you
in a peeling
action. Set
retainer aside.
panel(s) at
outer edges.
Use one hand
to bow bottom
of panel(s).
Remove
panel(s). Do Not
remove spacer.
J
3 n Insert one
I-
n
side of door
panel(s), with
desired color
facing out, into
one side of door
frame.
1 4 a Bow door
panel(s) and inset-i
other side of door
panel(s) into
door frame.
Page 9