IMPORTANT: Read and save these instructions. Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. electrical inspector’ Pat-t No.
Before you start... Check location where washer/dryer will be installed. Proper installation is your responsibility. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Make sure you have everything necessary for correct installation. Important: Observe all governing codes and ordinances. Check code requirements: Some codes limit or do not permit installation of clothes dryers in garages, closets, mobile homes and sleeping quarters.
5 W If you must change to a threewire, single-phase, 120/240-volt, 60-Hz, AC-only, electrical supply system, and local codes permit, a U.L.-listed, 120/240-v0lt minimum, 30ampere, dryer Figure 3 power supply cord kit with a receptacle of NEMA Type lo30R may be used. (See Figure 3.) This cord must contain three, No.-1 0 copper conductors with ring terminals or spade terminals with upturned ends on the washer/dryer end.
Now start... With washer/dryer in laundry area. 7 --7l!let valves are plastic. Do not crossthread. Personal Injury Hazard More than one person is required to lift, tilt or move the washer/dryer because of its weight and size. Failure to follow this instruction may result in personal injury. Truck only from rear to prevent damage. I : 5 product n Attach hose to bottom inlet valve opening first; then second hose to top inlet valve. Tighten couplings by hand.
B 0 A IO I n Before attaching water inlet hoses, run water through both faucets into a bucket. This will get rid of particles in water lines that might clog hoses. Mark which is the hot water faucet. 11 WAttach bottom hose (inlet marked “H”) to hot water faucet. Attach top hose (inlet marked ‘C”) to cold water faucet. Tighten the coupling to the faucet by hand. Use pliers to make final two-thirds turn. Move washer/dryer to its permanent location. Remove cardboard from under washer/dryer.
I Alternate electrical connection To convert to a three-wire electrical system When local codes... Electrical Shock Hazard Electrical ground is required on this appliance. l If cold water pipe is interrupted by plastic, non-metallic gaskets or other insulating materials, Do Not use for grounding. l Do Not ground to a gas pipe. l Do Not modify the power supply cord plug. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. l Use a new 30-ampere power supply cord kit.
When local codes... When local codes...
Recessed and closet installation instructions Product Recessed area minimum Fire Hazard It is recommended that the dryer be exhausted outside l If washer/dryer is installed in a closet, the dryer MUST be exhausted outside. Failure to do so may cause a fire. installation spacing dimensions 1+26-l/4’ a- 3” l This washer/dryer may be installed in a recessed area or closet. The installation spacing is in inches and is minimum allowable.
If washer/dryer not operate properly.. . does Check the following to be sure that: 1, Electric supply is connected. 2. House fuse or circuit breaker is intact and tight. 3. Washer lid or dryer door is closed. 4. Controls are set in a running or “ON” position. 5. Dryer start button has been firmly pushed. 6. Make sure shipping strap has been completely removed and was used to secure the drain hose to the tub or standpipe. If you need service... If you need assistance...