VL#l 4a Home 01 Appliances UseAndCare I A Note To You 2 Important Safety Instructions 3 Parts And Features 4 Before Using Your Refrigerator 5 Using Your Refrigerator 7 Caring For Your Refrigerator 23 Food Storage Guide 26 NO-FROST B REFRIGERATOR-FREEZERS W’TH T=m&!IgR’ MODELS 3VED29DQ “‘h-i 3VED27DQ 3VED23DQ
A Note To You Thank you folr buying a Whirlpool* appliance. You have purchased a quality, world-class home appliance. Years of engineering experience went into its manufacturing. To ensure that you enjoy many years of trouble-free operation, we developed this tJse and Care Guide. It is full of valuable information on how to operate and maintain your appliance properly and safely. Please read it carefully. Also, please complete and mail the Ownership Registration Card provided with your appliance.
Important Safety Instructions To reduce the risk of fire, electrical shock, or injury when using your refrigerator, follow these basic precautions: l l l Read all instructions before using the refrigerator. Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous even if they will “just sit in the garage a few days.” If you are getting rid of your old refrigerator, do it safely.
Parts And Features This section contains captioned illustrations. Use them to become familiar with where all parts and features are located and what they look like. Your refrigerator may have some or all of the features shown, and they may not look like the illustrations. This manual covers many models. Automatic ice maker with cubed and crushed ice Light (on some models) Model and serial number label (on side wall) / -A.
Before Using Your Refrigerator I I In This Section Page Page Cleaning it .......................................... .5 Installing Plugging it in.. .................................... .5 Leveling it properly .......................... .6 it ............................................ 6 It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it and level it.
Installing it properly 1. Allow 1.25 cm (I,$ inch) space on each side and at the tfop of the refrigerator for ease of installation. 2. If the refrigerator is to be against a wall, you might want IO leave extra space on the hinge side closest to the wall so the door can be opened wider. 3. The refrigerator can be flush against the wall. 4. Make sure ice maker water supply has been connected. Refer to Installation Instructions.
Using Your Refrigerator In This Setting Section the controls Page ............................ 8 settings.. Page Removing the snack bin ................. .I4 ........ .9 Adjusting the wine rack .................. .14 Changing the control Removing the door shelf fronts ....... .9 Removing the freezer baskets.. ...... .I4 Removing the door trim .................. .10 Removing the freezer shelf.. ........... .14 Adjusting the door bins .................. .10 Adjusting the door bin glides.
Setting the controls Controls for the refrigerator and freezer are in the refrigerator. When you plug in the refrigerator for the first time: 1. Set the Refrigerator Control to 3. Refrigerator Control adjustments range from 1 (warmest) to 5 (coldest). 2. Set the Freezer Control to B. Freezer Control adjustments range from A (warmest) to C (coldest). 3. Give the refrigerator time to cool down completely before adding food. This may take several hours.
Changing the control settings If you need to adjust temperatures in refrigerator or freezer, use the settings listed in the chart below as a guide. l l l Adjust the Refrigerator Control first. Wait at least 24 hours between adjustments. Then adjust the Freezer Control if needed. _______ CONDITION: Refrigerator section too warm Freezer section too warm Refrigerator section too cold Ice not made fast enough Both sections too warm Removing --.- .__.
Removing (on some the door trim models) Remove the trim above the dispenser area for easier cleaning. To remove trim: 1. Remove all items from the shelf. 2. Pull straight up at each end of the trim. To replace trim: 1. Line up each end of the trim above the trim pocket opening in the door liner wall. 2. Push the trim straight down until it stops. 3. Replace items on the shelf. Adjusting the door bins To remove door bins: 1. Lift bin up. 2. Pull bin straight out. To replace door bins: 1.
-.- Adjusting the door --.- bin glides Use the bin/shelf glides to secure oddshaped items or to separate other items. 1. Grasp glide. 2. Slide glide along bin/track. NOTE: Shelf glides cannot be removed. Adjusting the refrigerator shelves Adjust the shelves to match the way you use your refrigerator. Glass shelves are strong enough to hold bottles, milk and other heavy food items. To remove glass shelves: 1. Remove items from shelf. 2. Slide shelf out with an even, constant pull. 3.
Usiny the egg bin The egg bin has three pieces -the lid, the egg carrier, and the bin. Use the egg bin to hold one, two or three dozen eggs. / Lid To hold one dozen eggs: Place a dozen eggs into the egg carrier. Then place the egg carrier into the bin and cover with the lid. To hold two dozen eggs: Place two dozen eggs loose in the bin and cover them with the lid. Use the carrier to transport eggs between bin and your cooking area. To hold three dozen eggs: Place two dozen eggs loose in the bin.
Adjusting the crisper humidity co~ntrol You can control the amount of humidity in the moisture-sealed crisper. l The control can be adjusted to any setting between LOW and HIGH. l LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins. l HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables. Removing the meat drawer and cover Pull out to the stop, lift the front and pull again. To remove the meat drawer: 1.
Remcsvimq the snack bin To remove the snkk bin: 1 Slide snack bin straight out to the stop with an even, constant motion. 2. Lift the front. 3. Slide bin out the rest of the way. 4. Replace in reverse order. Adjusting the wine Pull out to the stop, lift the front and pull again. rack Step 2 To remove the wze rack: 1. Lift front of wine rack. 2. Pull rack off rear support. 3. Replace in reverse order.
Using the THIRSTCRUSHER’ system The dispensing ice dispenser Ice dispenses from the ice maker storage bin in the freezer. When you press the dispenser bar, a trapdoor opens in a chute between the dispenser and the ice bin. Ice moves from the bin and falls through the chute. When you release the dispenser bar, a buzzing sound may be heard for a few seconds as the trapdoor closes. The dispenser system will not operate when the freezer door is open. For crushed ice, cubes are crushed before being dispensed.
The water dispenser Chilled water comes from a tank behind the meat drawer. It holds approximately 1.5 L (1% quarts). When the refrigerator is first hooked up, press the water dispenser bar with a glass or jar until you draw and discard 1.9 to 2.8 L (2 or 3 quarts). The water you draw and discard rinses the tank and pipes. Allow several hours to chill a new tankful. NOTE: The small tray beneath the dispenser is designed to evaporate small spills. There is no drain in this tray. Do not pour water into it.
Using the automatic Here are a few things you will want to know about your automatic ice maker: l The ON/OFF lever is a wire signal arm. DOWN to make ice automatically. UP to shut off the ice maker. NOTE: Do not turn ice maker on until it is connected to the water supply. Instructions for ice maker water supply hook up are attached to the back of the refrigerator cabinet. l It is normal for ice crescents to be attached by a corner. They break apart easily.
Removing the ice maker Remove, empty and clean the storage bin if: l the ice dispenser has not, or will not, be used for a week or more. l a power failure causes ice in the bin to melt and freeze together. l the ice dispenser is not used regularly. To remove ice bin: 1. Pull the covering panel out from the bottom and slide it to the rear. 2. Lift the signal arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made. 3.
Solving problems common PROBLEM CAUSE Ice dispenser won’t work l ice maker/dispe!nser ---- --l l l Ice dispenser stops working l Freezer door open Ice bin not properly installed Wrong ice in bin Dispenser not used for extended periods, causing ice cubes to melt together -Ice dispenser bar held in too long l l l l l l Off -taste or odor in ice l l -Ice attracts airborne odors; old ice Water quality l l l Foods not properly wrapped Ice bin and freezer may need cleaning Plumbing to ic
Removing the base grille To remove the grille: 1. Open both doors. 2. Pull base grille forward to release the support tabs from the metal clips. 3. Do not remove Tech Sheet fastened behind the grille. Condenser coils -_-- To replace the grille: 1. Line up grille support tabs with metal clips. 2. Push firmly to snap into place. 3. Close the doors. grille See cleaning instructions for defrost pan and condenser coils on page 24.
To change light below ice bin: 1. Disconnect refrigerator from power supply. 2. Push in sides of light shield until it snaps free. 3. Replace bulb with a 40-watt appliance bulb. 4. Replace light shield. 5. Reconnect refrigerator to power supply. To change light behind quick freeze compartment (on some models): 1. Disconnect refrigerator from power supply. 2. Lift and secure quick freeze compartment door. 3. Remove light shield by pulling top forward. 4. Replace bulb with a 40-watt appliance bulb. 5.
Understalnding the sounds Your new refrigerator may make sounds thal your old one didn’t. Because the sounds are new to you, you might be concerned about them. Don’t be. Most of the new sounds are normal. Hard surfaces like the floor, walls and cabinets can make the sounds seem louder. The following describes the kinds of sounds that might be new to you, and what may be making them.
Caring For Your Refrigerator In This Section Cleaning your refrigerator Vacation and moving Page . .. . .. .. . .. . ... 23 Page Power interruptions . . ... . .. . ... . .. . .. .. .. .. . . 25 care . .. .. . .. . .. . .. . 24 Your refrigerator is built to give you many years of dependable service. However, there are a few things you can do to help extend its product life.
PART ~-_ .___.Door liners and gaskets --. Plastic parts (covers and panels) -------_-Defrost pan WHAT TO USE ---Sponge, soft cloth or paper towel with mild detergent and warm water Soft, clean sponge or soft, clean cloth with mild detergent and warm water Sponge or cloth with mild detergent and warm water HOW TO CLEAN Wash, rinse and dry thoroughly. DO NOT USE cleaning waxes, concentrated detergents, bleaches or cleaners containing petroleum on plastic parts. l Wash, rinse and dry thoroughly.
Long vacations If you will be gone a month or more: 1. Remove all food from the refrigerator. 2. Turn off the water supply to the ice maker at least one day ahead of time. 3. When the last load of ice drops, turn off the ice maker. Make sure all ice is dispensed out of the ice maker mechanism. 4. Unplug the refrigerator. 5. Clean it, rinse well and dry. 6. Tape rubber or wood blocks to the tops of both doors to prop them open far enough for air to get in. This stops odor and mold from building up.
Food Storage Guide There is a correct way to package and store refrigerated or frozen food. To keep food fresher, longer, take the time to study these recommended steps. Storing fresh food Wrap or store food placed in the refrigerator in airtight and moisture-proof material. This prevents food odor and taste transfer throughout the refrigerator. For dated products, check code date to ensure freshness. Leafy vegetables Remove store wrapping and trim or tear off bruised and discolored areas.
I ’ Storing frozen food The freezer section is designed for storage of commercially frozen food and for freezing food at home. NOTE: For further information about preparing food for freezing or food storage times, check a freezer guide or reliable cookbook. Packaging The secret of successful freezing is in the packaging. The way you close and seal the package must not allow air or moisture in or out.
If You Need Assistance Service Or Performance problems often result from little things you can fix without tools. Please read the chart below before calling for service on your appliance. 1. Before calling for assistance ... Listed in this chart are the most common problems consumers Please read through this and see if it can solve your problem. run into with their appliances.
2. If the problem is not due to one of the items listed in Step I+ . . . Contact the dealer from whom you purchased the unit or an authorized Whirlpool* service company. 3. If you need ment parts+ FSP’ ... replace- FSP is a registered trademark of Whirlpool Corporation for quality parts. Look for this symbol of quality whenever you need a replacement part for your Whirlpool appliance.
WHIRLPOOL* Refrigerator Warranty LENGTH OF WARRANTY WHIRLPOOL FULL ONE-YEAR WARRANTY From Date of Purchase FSP@ replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by an authorized Whirlpool service company. FULL FIVE-YEAR WARRANTY From Date of Purchase FSP replacement parts and repair labor to correct defects in materials or workmanship in the sealed refrigeration system. These parts are: 4. Drier 1. Compressor 5. Connecting tubing 2.