UNDERCOUNTER DISH WASHER Use & Care Guide
Table Of Contents
- you are responsible for
- table of contents
- important safety instructions
- energy saving tips
- using your dishwasher
- before starting your dishwasher
- starting your dishwasher
- cycles and options (models with one cycle)
- cycles and options (models with three cycles)
- cycles and options (models with three buttons)
- cycles and options (models with five buttons)
- cycles and options (models with seven buttons)
- to add a dish after starting
- changing a setting
- proper loading
- adding detergent
- using rinse agent
- for best results
- dishwasher care and cleaning
- common dishwashing problems
- before you call for service
- warranty
Before You Call For Service
If you are having an operating problem,
check the list to see what the cause
might be before you call for assistance.
OPERATING PROBLEM
Dishwasher will not run, or
stops during a cycle.
CHECK IF’
. Dishwasher is properly connected
to a live circuit with the proper
voltage.
WHATTODO
H Contact qualified service technician
to reconnect dishwasher to
electrical supply. (See Installation
Instructions.)
n
Home fuse or circuit breaker has
blown or tripped.
. Water is turned on.
n
Motor has stopped because of an
overload.
m Replace fuse or reset circuit
breaker.
H Open water valve to dishwasher.
n
Motor will automatically reset
itself
within a few minutes. If the motor
does not start, call for service.
n
Door is tightly closed and securely
n
Press firmly against door.
latched.
.
Cycle has been correctly set.
n
Reset cycle following steps on
page 4, 5 or 6.
Dishwasher won’t fill.
n
Overfill protector is stuck in “up”
n
Overfill protector should move up
position.
and down freely. Press down to
release.
Water remains in the
dishwasher.
. The cycle has completed.
n
Wait for the cycle to finish.
A
small
amount of remaining water is
normal.
.
Dram air gap is clogged.
a Clean dram air gap. (See
Installation Instructions.
Detergent remains in the
covered detergent cup.
.
The bottom rack is in properly.
. The dishwasher detergent is fresh
and dry without lumps.
n
Place the rack with the rack
bumpers at the front.
n
Replace old detergent with fresh.
m The cycle has completed.
I Wait for the cycle to finish.
White residue appears on front
of access panel.
n
Too much detergent is being used.
n
See page 8 for recommended
amounts of detergent.
n
Your liquid detergent is developing
n
Try a different brand to reduce
excess foam and building up on
foaming and eliminate build-up.
exterior of access panel.
Dishes aren’t as dxy as you
expected.
. Rinse agent dispenser is empty.
n
Fill rinse agent dispenser. Using a
rinse agent greatly improves drying.
(See page 9.)
Page 15