UNDERCOUNTER DISH WASHER Use & Care Guide

Using Your Dishwasher
The drawings in this book may vary
slightly from your dishwasher model.
They are designed to show the different
features of all the models covered by this
book.
NOTE: Your model may not include all
the features shown.
-- Filter system screen
(not shown)
EKtra-CSpXlty
fold down shelf
(on some model
Third level wash
(on some models)
Extra-capaclty
Silverware bask
(on some models)
Water Inlet opening
Bottom rack
lIverware basket
Lower spray arm
Overfill protector
Heating element
etergent dispenser
1 y Access panel
h
Door color panel
Model and serial
klnse agent dispenser
number label
(on dght side)
SlIverware basket
(on some models)
Before starting dishwasher
1. Read “Important Safety
Instructions” on page 2 before
starting your dishwasher.
2. Properly load the top and bottom
racks, and silverware basket. (See
pages 7 and 8.)
3. Spin the lower spray arm to make
sure nothing will stop it from
turning freely.
4. Add detergent. See page 8.
5. Check rinse agent dispenser. See
page 9.
6. Push door firmly when closing and
it will automatically latch.
7. Run hot water at sink nearest
dishwasher until it is hot. Turn it
Off.
Starting dishwasher
1. Select a drying option. (Select
ENERGY SAVER when using the
Rinse & Hold Cycle.)
2. Select any other desired options
that are available.
Model6 with RESET OPTIONS
Button - Options may be changed
or cancelled by pushing the RBSET
OPTIONS Button, then pushing
new Option Selector Button(s).
All other models - Options may be
changed or cancelled by pushing
another Option Selector Button.
3. Turn the Cycle Control Knob
clockwise to point to a desired
cycle. You will feel a definite stop
at each cycle mark. The dishwasher
will automatically start that cycle.
NOTE: If the door is latched, you will
hear cycles start and stop as the knob
passes each cycle mark. This is normal
and will not hurt the dishwasher. If you
prefer, you can set cycles with the door
unlatched.
Page 3