Service manual

2-4
c) Lift the cable clamp, remove the motor
cable, and remove the blower motor
from the hood.
f) Remove the four motor bracket mount-
ing screws from the center of the motor
housing, and pull the motor and bracket
out of the housing.
g) Remove the mounting nut from each of
the blower wheels and remove the
wheels from the blower motor.
d) Position the blower motor on a work
surface on one of its sides.
e) Remove the five screws from the blower
motor housing side cover that is facing
up and remove the cover. NOTE: Do
not remove the plastic grille from the
cover.
Housing Side Cover
Side Cover Screw
(1 of 5)
Motor Bracket
Screw (1 of 4)
Blower Wheel Nut
Cable Clamp