Manual

4, Set cycle settings and options
(on some models)
_ WRmNKLE SHmELD
fabrc
Select cycle settings and options by turning the knob to the
desired position.
TEMPERATURE/FABRIC Ion some models)
Turn the TEMPERATURE/Fabric knob to change the drying
temperature setting. See "Setting the Drying Temperature".
WRINKLE SHIELD FEATURE (on some models)
[] Get up to 40 minutes of heat-free, periodic tumbling at the
end of a cycle. Turn the WRINKLE SHIELD knob to select
ON or OFF at any time before the cycle has ended.
NOTE: Not all options and settings are available with all cycles.
6, Press PUSH to START to
begin cycle
PUSHTO START
Appearance may vary
Push and hold the PUSH to START knob to begin the cycle.
Promptly remove garments after cycle has completed to
reduce wrinkling. Use the Wrinkle Shield feature to avoid
wrinkling when you are unable to remove a load from the dryer
as soon as it stops.
5, Select End of Cycle Signal, if
desired (on some models)
Turn the END OF CYCLE SIGNAL knob to select the desired
setting (On or Off). The End of Cycle Signal produces an audible
sound when the drying cycle is finished. Promptly removing
clothes at the end of the cycle reduces wrinkling.
NOTE: When the Wrinkle Shield setting is selected and
the End of Cycle Signal is on, the tone will sound every
5 minutes until the clothes are removed, or the Wrinkle
Shield setting ends.
8