CHANGING THE BIN DOOR PANEL The storage bin optional decorative door is designed to accept wood panel of your choice. an The wood panel should be no more than ‘A inch (6 mm) thick. Cut it to the same size as the production metal panel. See Figure 1. To change 1. the panel: Open the bin door. Remove 4. Slide 5. Break off the allow for the wood 6. Slide 7. Replace on top of the the 13-3116” wood handle panel out. ribs on the door insulation thickness. See Figure 2.
GENERAL INFORMATION l UNPACK 2 Either a gravity drain system or a sump the water to an exrsting drain. pump to flft 3 An electrical branch clrcult of 115 Volt, 60 Hz. phase, with a 15 Amp delayed actron fuse. 1 . LOCATE UNIT THIS UNIT MUST BE INSTALLED IN AN AREA PROTECTED FROM THE ELEMENTS, SUCH AS WIND, RAIN, WATER SPRAY OR DRIP. INTERIOR PACKING OPEN BOTTOM FIGURE d Lay carton flaps. FIGURE on rear 2 Set carton upright See Figure 3.
FOR THE PLUMBER CONNECT TO WATER SUMP PUMP (observe local -codes) 1 When a drain connectlon IS not avallable. a sump the water to an avarlable 2 Install sump pump on floor behind ice maker with discharge tube to the rear. Run bin drain directly Into sump pump as shown In the Illustration. 1 Use 114” OD soft copper tubing for the cold water supply. 2 Provide a convenrent water line.
FOR THE ELECTRICIAN ELECTRICAL REQUIREMENTS A 115 Volt, 60 Hz, AC only, 15 Amp fused electrical supply IS required (time delay fuse or circuit breaker is recommended). It is recommended that a separate circuit, serving only this appliance, be provided. DO NOT use an extension cord. ELECTRICAL APPLIANCE. GROUND IS REQUIRED ALTERNATE GROUNDING METHOD DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD GROUND PRONG.
THINGS TO REMEMBER HOW IT WORKS 0 Compressor runs 0 Condenser fan runs 0 Water pump 0 Cutter grid runs (circulates is warm WHEN THE DESIRED ICE SLAB THICKNESS IS REACHED, THE HARVEST CYCLE BEGINS AND THE FOLLOWlNG HAPPENS: Evaporator thermostat 0 Compressor keeps 0 Condenser fan stops 0 Water 0 Hot gas solenoid opens 0 Water opens 0 Excess 0 Cutter NOTE: pump inlet water grid running or turns is flushed is warm Normal out of the dram harvest remains The unit will
UNIT WIRING CUBELET DIAGRAM CUTTER GRIDS I- This model operates at 115 volts except for the cutter grid circuit which operates at 8.5 volts at 1 amp. he compressor runs at all times except when the bin thermostat becomes satisfied and opens up. This de-energizes the system except for the transformer and cutter grid.
Quality. Our way of life. Benlon Harbor Mlchlgan. Aulomallc Washers. Clothes Dryers Freezers Relrlgeralor.Freezers Ice Makers. DIshwashers Bu~ll-ln Ovens and Surlace Unlls. Ranges MIcrowave Ovens Compaclors Aoom Air Condllloners Oehumldlllers Cenlral Heallnq and Air Condlllonlng Syslems Part No 756638-Rev A Printed in U.S.