INSTRUCTIONS FOR USE INSTALLATION INSTRUCTIONS BEFORE USING THE APPLIANCE PRECAUTIONS AND GENERAL ADVICE ENERGY SAVING TIPS OVEN ACCESSORIES CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE For best use of the oven, carefully read the operating instructions and keep them for future consultation.
INSTALLATION INSTRUCTIONS This appliance is in Class 1. The appliance must be used with the gas specified on the rating plate located on the inside of the drawer door (see details given on the product) Installation and maintenance of the appliance must be carried out by a qualified technician in compliance with the conditions established in the applicable regulation documents and the ethical codes.
Gas connection For information regarding gas connection instructions, see the section on “standards” relevant to your country (see attached leaflet “References to National Regulations”). The gas supply system must comply with current local regulations. The appliance must be connected to the gas supply or gas bottle by means of a rigid copper or steel pipe with fittings conforming to local regulations or by means of a s/steel hose without breaks, conforming to local regulations.
Gas adjustments Use pressure regulators that are suitable for the gas pressure values indicated in the Product Description Sheet supplied separately. If the appliance is arranged for a type of gas different from that available, it is necessary to change the injectors, adjust the minimum flame, change the outlet connector. Carry out the following operations to change the hob injectors: remove the grills; remove the burners, the burner caps (see Fig.
For the indispensable introduction of fresh air in the room, a similar opening of at least 100 cm2 directly to the outside must be provided at a height near floor level so as not to be obstructed on the inside or outside of the wall and not to hinder the correct combustion of the burners and the regular extraction of vitiated air, and with a height difference of at least 180 cm with respect to the outlet opening.
Installation IMPORTANT: The covering of the cabinets must be in heat resistant (min. 90°C) material. If the appliance has to be installed near furniture, ensure the minimum spaces given in the following figure. The appliance is equipped with 4 feet that are used for possible height alignment with the cabinets. To fit them, tilt the appliance and screw the 4 feet in the special threads located in the corners (see fig. 1). Fig.
BEFORE USING THE APPLIANCE • Remove the accessories from the oven and heat it at 200°C for about two hours to eliminate the smell of protective grease and insulating materials. It is advisable to keep the window open during this operation. • Before use, remove: - stickers located on the front of the appliance and on the oven door, except the rating plate; - cardboard protection and protective plastic film on the control panel and other parts of the appliance; - any stickers on the accessories (e.g.
• Keep children away from: - the controls and the appliance in general, especially during and immediately after use: risk of injury; - packaging (bags, polystyrene, metal parts, etc.); - the appliance being scrapped. • Make sure that the electrical cables of any other appliances used near the oven do not touch hot parts or get caught in the oven door. • Do not place flammable material in the oven or nearby: risk of fire if the oven is inadvertently switched on.
OVEN ACCESSORIES The accessories supplied depend on the model. The accessories supplied with the oven are listed in the separate Product Sheet (at the point Accessories). Drip tray (1) Used for collecting fat and bits of food when placed under the grill, pour a little water in the drip tray to prevent splashes of fat and smoke. The drip tray can be used as a container for cooking meat, chicken and fish with or without vegetables. Fig.
OVEN ACCESSORIES Children safety device (according to the models) The children safety device can be removed by following the sequence of images.
CARE AND MAINTENANCE Disconnect the appliance from the electrical power supply before carrying out any cleaning operation. • Clean using a cloth moistened with warm soapy water or diluted liquid detergent. • Do not use abrasive or corrosive products, chlorine products or steel wool. • Do not use steam cleaners. • Do not use flammable products. • Do not leave acidic or alkaline substances such as vinegar, salt, lemon juice, etc., on the hob. Stainless steel surface • Clean with a specific commercial product.
Removing the door Important: it is advisable to use protective gloves for the following operations. To prevent possible injury and to avoid damaging the oven door and hinges, carefully follow these instructions. The oven door can be removed as follows: 1. for this purpose the hinges A are provided with movable U bolts B which hook onto the sectors of hinges C when they door is completely open, locking it; 2. lift the door outwards, carrying out the two movements shown in the figure; 3.
TROUBLESHOOTING GUIDE 1. The appliance does not work 3. The burner does not stay lit • Check the mains power supply and that the appliance is electrically connected. • Switch the appliance off and on, to see if the problem has disappeared. 2.