Instructions / Assembly

Model # 7LIECK-W-WL
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5-WHIRL-5 for assistance.
UNPACKING AND ASSEMBLY
Remove the dispenser from packaging:
1. Lay dispenser on its side.
2. Open bottom flaps of the cardboard box.
3. Stand cooler up with flaps unfolded.
4. Pull box straight up.
5. Unpack the drip tray and insert it into the dispenser.
(See illustration )
6. Keep original packing for the duration of warranty.
TO OPEN:
TOP
TOP
TOP
TOP
INSTALLATION
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
WARNING
Tip Over Hazard
Do not use water cooler until base is attached to
bottom of water cooler.
Failure to do so can result in death or serious injury.
WARNING
1. Locate the dispenser on a hard and level surface in a cool
shaded location near a grounded wall outlet.
2. Position dispenser so that the back is at least 4 inches from
the wall and there are at least 4 inches of clearance on both
sides.
3. To minimize vibration and noise, make sure that all 4 feet are
adjusted to keep dispenser levelled.
4in. Min
4 adjustable feet