Installation guide

Reverse door swing round-shaped door = double handle
1, Remove door from dryer
® ®
®
iMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a TORX T25®screwdriver, remove the 4 screws
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Reinstall the 4 screws in the holes.
® ®
® ®
®
Using a TORX T25®screwdriver, remove the 2 screws
securing the door strike to the door frame of the dryer. Rotate
the strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
A
3, Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4. Remove hinge and latch
g Latch
Hinge
T25 screwdriver, remove the 3 TORX ®screwsUsing a TORX ®
securing the latch plate and latch backing plate and the 5
screws holding the hinge assembly in place.
19