Installation guide

Reinstall hinge and latch on

opposite sides

Using a TORX T25®screwdriver reinstall the latch plate and

latch backing plate with the 3 TORX ®screws removed earlier

and the hinge assembly with the 5 screws on the opposite

sides from which they were removed.

6, Reinstall inner door assembly

Bottom

of door

Position the door with the inside of the door facing up.

Reinstall the 10 screws securing the inner door to the

outer door.

Using a TORX T25®screwdriver, remove the 4 screws on the

dryer. Insert the tabs on the hinge into the mounting slot and

slide down to engage the top tab. Secure in place with

the 4 TORX T25 ®screws removed earlier.

Reverse door swing square-shaped door

1, Remove door from dryer

Using a TORX T25®screwdriver, remove the 4 screws

securing the door hinge to the dryer and lift up and out to

remove the door. Place the door on a soft towel or other

non-scratch surface. Retain or set aside the 4 screws.