Installation guide

Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Wiring configuration
Power supply wire: Terminal box ‘wire:
white <——> white
black ———»- black
ground wire ~—«———» ground connector
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/electrical under FAQ tab.
4 | Direct Wire—Secure cable
-— in strain relief
Direct Wire—Reinstall
terminal box cover
a
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 4" nut driver or Torx T20 screwdriver
and previously removed screw to secure cover.
Pt
8 pun pone ay Po pey garrygend cep ye gery, PP racy tay 6 wpe, gam, Bs GOP ry perp ore, G wpe
bey pis, ay ea ye. yw eee poy y iy, Bs XY
secure Dishwasher in Cabinet Opening SS
Double-check dishwasher
alignment in cabinet opening
Check that dishwasher is still level front-to-back and side-to-side
in cabinet opening.
Open dishwasher door, remove lower dish rack, and place towel
over pump assembly and lower spray arm of dishwasher. This will
keep screws from falling into pump area when you are securing
dishwasher to countertop.
3 | Secure dishwasher
NOTE: Do not drop screws into bottom of dishwasher. Locate
brackets on top of dishwasher and secure dishwasher to
countertop with two, #10 x 4%" Phillips-head screws (included).
The dishwasher must be secured to keep it from shifting when
door is opened.
21