Troubleshooting guide

25
WASHING PROGRAMME
Selecting the programme:
1.
Plug in the appliance.
2.
Turn on the water supply tap.
3.
Set the
Programme Selector
knob to the desired programme.
4.
Select additional
options
, if desired, pressing the corresponding button.The indicator lights up.
By a
further pressing
of the button this option can be turned off again.
5.
Press the
“Start/Pause”
button.
The indicator light will come on and the programme duration is shown on the display (if available).
The indicator lamps show the sequence reached in the programme. After starting the programme, the
sequence indication runs from left to right through Wash, Rinse, Spin.
When the sequence of the programme is finished the corresponding lamp goes out.
Options
(depending on model)
Easy Ironing •
Can be used together with Cotton and Synthetics programmes to make ironing
easier.
•
Increases the water quantity and the clothes are spun very gently.
Energy save/
Eco
•
Increases the programme time and reduces the temperature. This reduces energy
consumption by about 30% without compromising the excellent results of the
wash.
Prewash •
Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle
time increases approximately 15 min.
Quick wash /
Rapid
•
Select for quick, economical washes.
•
Especially suitable for small, lightly soiled loads.
Note:
If “Quick wash” is selected, only the “Rinse Hold” and “Spin speed reduction”
options can be activated.
Intensive
Rinse
•
More water and a longer time in rinse cycle is added.
•
The intensive rinse function is especially suitable for areas with particularly soft
water, for baby clothes and to help people with allergies.
Rinse hold /
Spin delay
•
The laundry remains in the last rinse water without being spun, to avoid heavy creasing.
•
Especially suitable for the “Synthetics” or “Delicates” programmes, if the laundry
is not to be unloaded immediately after the end of the programme. This function
is particularly useful if you want to postpone spinning to a later time or when you
do not wish to spin the clothes.
Note:
The programme stops to “Rinse Hold” at the time the “Rinse Hold” light in the
programme flow indication is on.
Continuing wash cycle after rinse hold:
•
Press the Rinse hold button again; the load will be spun according to the selected
programme.
•
If you do not wish to spin the clothes, turn the programme selector knob to the
drain programme and press the
“Start/Pause”
button
Spin speed
reduction
•
Press this button to reduce the predetermined automatic maximum spin speed. In
some programmes the maximum final spin speed is limited to go easy on your
laundry items. Selection of a higher spin speed is not possible.
•
With the “Cotton” and “Synthetics” programmes a short spin cycle is provided in any case,
even if the exclusion has been selected, in order to optimize rinsing results.
•
If the spin speed “0” is selected, the final spinning is cancelled. The water is
drained out only.
3gb05112.fm5 Page 25 Tuesday, November 21, 2000 4:36 PM
Black Process Plate