Instructions / Assembly

ASSEMBLY
INSTALLATION
WARNING
Keep plastic bags away from children.
1. Remove dispenser from packaging.
2. Unpack drip tray and insert into dispenser.
3. Remove protective packaging from around probe.
4. Properly dispose of all packaging materials.
12
1. Place water cooler upright.
2. Locate water cooler on a hard and level surface in a cool shaded location
near a grounded wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position water cooler so the back is at least 4 inches from wall and there
are at least 4 inches of clearance on both sides.
4. To minimize vibration and noise, make sure dispenser is level.
Notice: Do NOT plug in power cord yet.
Make sure RED power switch is turned OFF before plugging power cord
into an outlet for the first time.
Check if water filled hot tank by dispensing hot water, Trun RED power
swith ON.