Manual

11
Locate transport bolts
Locate four transport bolts on rear of machine.
Remove transport bolts from All-In-One Washer
Dryer
Loosen bolts with a 5/8" (16 mm) wrench.
Remove each bolt from machine, by pulling in the direction of
the arrows, pull bolts and plastic spacers from back of machine.
Discard bolts and spacers.
NOTE: Do not plug machine in until installation has been
completed.
REQUIREMENTS
Tools and Parts
Tools and Parts
Adjustable or open end
wrenches 1/2" (13 mm), 5/8"
(16 mm) and 9/16" (14 mm)
Level
Ruler or measuring tape
Pliers that open to 1
9
/
16
"
(39.5 mm)
Optional tool
Flashlight
Bucket
Parts supplied with machine
NOTE: All parts supplied for installation are in the machine
basket.
Water inlet hoses (2)
Flat inlet hose washers (4)
Cable tie Drain hose with clamp and
form (may be shipped
unassembled)
Available accessories:
An optional matching pedestal is available for your machine.
Please contact your retailer for ordering information, or see the
“Assistance or Service” on Quick Start Guide.
Alternate parts (not supplied with machine):
Your installation may require additional parts. To order, please refer
to toll-free numbers on Quick Start Guide.
If you have: You will need:
Overhead sewer Standard 20 gallon (76 L)
39" (990 mm) tall drain tub or
utility sink, sump pump and
connectors (available from
local plumbing suppliers)