Manual

12
Location Requirements
Proper installation is your responsibility.
You will need:
n A water heater set to 120°F (49°C).
n A grounded electrical outlet located within 6 ft (1.8 m) of
power cord on back of machine.
n Hot and cold water faucets located within 4 ft (1.2 m) of hot
and cold water ll valves on machine, and water pressure of
0.03-0.7 MPa.
n A level oor with maximum slope of 1" (25 mm) under entire
machine. Installing on carpet or surfaces with foam backing
is not recommended.
n Floor must support machine’s total weight (with water and
load) of 315 lb (143 kg).
IMPORTANT: Do not install, store, or operate machine where it
will be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in machine after use may cause damage in low
temperatures. See “All-In-One Washer Dryer Care” for winterizing
information.
Whirlpool
®
Models*
*For additional details (or information) specic to your model, refer
to the ‘Dimensions’ listed for your model at
www.whirlpool.com.tw.
Custom under-counter installation:
38
5
/8"
(981.5 mm)
27"
(686 mm)
54
7
/8"
(1393 mm)
31
9
/16"
(802 mm)
39" minimum
(991 mm)
1"
(25 mm)
27"
(686 mm)
1"
(25 mm)
Recessed area or closet installation:
Custom cabinet installation:
0.25"
(5 mm)
24 in
2
(155 cm
2
)
48 in
2
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)
0.25"
(5 mm)
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)