Manual

24
TROUBLESHOOTING
F# E# or F## E## code
other than as described
above appears in display
System error code. Touch POWER once to clear the code. Then touch POWER
again to restart washer dryer. If code appears again, call for
service. Unplug washer dryer for 30 seconds, then plug back
in.
Washer dryer making error
beeps
Door has not been opened and
closed for at least 3 cycles.
This code may occur when the washer dryer is rst turned on.
Open and close the door to clear the display.
Washer dryer beeps when
START is touched
Door not closed. Close the door completely.
Clean Washer LED ashing
at end of wash cycle
(on some models)
The washer dryer has run 30 wash
cycles and is indicating a reminder
to run the Clean Washer with affresh
cycle.
Run the Clean Washer with affresh cycle. If the Clean Washer
with affresh cycle is not turned on, the LED will stop ashing
at the end of a wash cycle after running 3 more regular wash
cycles. After 30 more wash cycles are completed, the Clean
Washer with affresh LED will again ash at the end of a wash
cycle as a reminder.
"Cool Down" appears in
display
During normal operation, this icon
may appear during the end of the dry
cycle if the load needs additional time
to cool down.
It is normal for the icon to appear, it will disappear when cool
down has nished.
First try the solutions suggested here or visit our website at www.whirlpool.com.tw
If you experience Possible Causes Solution
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING